How to replace carpet and clean cement 1.
Clean concrete floor under carpet.
This includes removing carpe.
Leaving the glue on the floor is not a good option because it can collect grime.
Sweep the concrete floor well using a broom and dust pan.
This video shows the steps that must be taken in preparation for staining concrete floors.
Lay the sheet over the concrete floor dimples down overlap adjacent edges and tape the seams.
Fans bleach and cleaners.
Wear chemical resistant gloves and eye protection and use a sponge or scrub brush.
The concrete floor should be completely free of all adhesive residue dust and dirt before applying a cleaning solution.
Dimpled polyethylene underlayment is available from home centers flooring suppliers or online.
Remove any loose carpet padding to reveal the concrete.
If the padding is adhered to the floor cut it into sections.
Add the plywood layer on top and anchor it to the concrete with 15 concrete screws predrilled and countersunk per 4 x 8 ft.
The sooner you start cleaning up after water damage the sooner you can stop mold from growing under your carpet.
Remove the 3 foot wide carpet sections from the tack strips by shaking the carpet in a back and forth motion while pulling it up from the surface of the floor.
Remove the old carpet.
When finished make sure to rinse the concrete using clean water and a mop or hose.
Rinse the concrete with water once the carpet glue is gone.
It s a sound theory but should only be executed by a professiona.
It also makes applying a concrete stain color challenging because the stain can t get past the glue to do its job.
The good news is removing carpet glue from a concrete floor is possible.
If you ever wanted to replace your carpet with stained concrete you should watch this first.
Carpet adhesive is stubborn and difficult to remove.
Put on a pair of rubber.
The tools are simple.
Clean the concrete with a solution of 1 2 cup trisodium phosphate to 2 gallons of warm water.
For grease oil and.
Pull back a corner of the carpet using a pair of pliers.
Red cross officials say many homeowners can get rid of the mold just fine after a flood but it will require a bit of elbow grease.
The carpet will be connected to the concrete surface via a series of wooden strips to which the carpet is tacked.
Wedge a pry bar between the carpet and wall and pry the carpet loose on all sides.